Falcon R-Class | User Guide
63
Voice VLAN
The Voice VLAN feature enables voice traffic forwarding on the Voice VLAN, then the switch can
classify and schedule network traffic. It is recommended that there be two VLANs on a port - one for
voice, one for data. Before connecting the IP device to the switch, the IP phone should configure the
voice VLAN ID correctly. It should be configured through its own GUI.
4.6.7.1
Voice VLAN Configuration
Web GUI: Configuration > Voice VLAN > Configuration
Figure 4-38: Voice VLAN Configuration display.
Table 4-35: Voice VLAN Configuration parameters.
Voice VLAN Configuration
Indicates the Voice VLAN mode operation. We must disable MSTP feature before
we enable Voice VLAN. It can avoid the conflict of ingress filtering. Possible
modes are:
•
Enabled
: Enable Voice VLAN mode operation.
•
Disabled
: Disable Voice VLAN mode operation.
VLAN ID
Indicates the Voice VLAN ID. It should be a unique VLAN ID in the system and
cannot equal each port PVID. It is a conflict in configuration if the value equals
management VID, MVR VID, PVID etc. The allowed range is
1
to
4095
.
Aging Time
Indicates the Voice VLAN secure learning aging time. The allowed range is
10
to
10000000
seconds. It is used when security mode or auto detect mode is
enabled. In other cases, it will be based on hardware aging time. The actual aging
time will be situated between the [age time; 2 * age time] interval.
Traffic Class
Indicates the Voice VLAN traffic class. All traffic on the Voice VLAN will apply this
class.
