Festo VABA-10S6-X Series, Manual, Page: 153 / 196

5. CPX pneumatic interfaces
5−17
Festo P.BE−CPX−EA−E N en 0804g
M od u l e p a r a m ete r s : M o ni t or in g w i r e fr a c tu r e c h ann e l x
(o n ly C PA an d VTSA p n eu m a t i c s )
Function no.
channel 0
Ū
7:
channel 8
Ū
15:
channel 16
Ū
23:
channel 24
Ū
31:
4828 + m * 64 + 6 m = module number (0
Ū
47)
4828 + m * 64 + 7
4828 + m * 64 + 8
4828 + m * 64 + 9
Description Determines whether Monitoring Wire Fracture for the relevant channel is active
or inactive
(CPA: channel 0
Ū
21
VTSA/ISO: channel 0
Ū
31)
Monitoring wire fracture output channel ...
0 = inactive (presetting)
1 = active [Monitor open circuit Out Ch ...]
[Inactive]
[Active]
Note With Monitoring Wire Fracture, a missing valve or a wire fracture (connection
fault between the pneumatic interface and the valve coil) is recognized.
[...] = display in the Handheld
Tab.5/5: Monitoring wire fracture channel x (channel−specific)
M od u l e p a r a m ete r s : F ai l s a f e c h ann e l x
Function no. Access to these module parameters is made via protocol−specific functions
(see the manual for the bus node).
Description Fault mode channel x: Hold last state
Fault state (presetting)
Fault state channel x: Set output
Reset output (presetting)
Note With the aid of the so−called Fail safe parameterizing, you can specify the
signal status which the outputs are to assume in the event of field bus
communication faults (see also CPX system manual).
Tab.5/6: Fail safe channel x (channel−specific)