Festo DGC G Series, Repair Instructions

Page: 84 / 136

36 / 44 Festo 7DGC-GFa_en
Place the stop plates on the slide-piston connection from the side. •
Apply Loctite 243 to the socket head screws and tighten them using the •
appropriate torque (see table).
Type Torque
DGC-50-…-GF 2.0 Nm ±20%
DGC-63-…-GF 2.0 Nm ±20%
Grease the sealing rings and insert them into the respective fixture in both •
end caps.
Attach the respective end caps to the cylinder barrel on both sides and align
•
each rear and lower edge of both end caps flush with the cylinder barrel.
Apply Loctite 243 to the socket head screws and tighten them using the •
appropriate torque (see table).
Type Torque
DGC-50-…-GF 25 Nm ±20%
DGC-63-…-GF 30 Nm ±20%
Note
After the linear drive has been assembled, it needs to be commissioned as
described in chapter 7 of the operating instructions.
Replacing the slide elements in the slide 4.2.3
If the slide elements in the slide are faulty or worn, they will have to be replaced.
Remove the slide as described in • chapter 4.2.1.
Remove the slide elements from the slide. •
Unfasten the socket head screws on the top of the slide and remove them. •