Festo DGC G Series, Repair Instructions

Page: 24 / 136

24 / 48 Festo 07DGC-Ga_en
Remove the coupling. •
Insert the new coupling in the slide. Apply Loctite 243 to the socket head •
screw and screw in the socket head screw. Do
not tighten the screw yet.
Place the slide, including the piston, on the cylinder barrel as described in •
chapter 4.1.2.
Tighten the socket head screw using the appropriate torque (see table).
•
Type Torque
DGC-8-…-G 1.4 Nm
DGC-12-…-G 1.4 Nm
Replacing the cushioning components 4.1.6
Unfasten the lock nuts on the cushioning components. •
Note
The cushioning components can be replaced even when the end caps are
attached.
Unscrew the cushioning components from the end caps. •
Insert the new cushioning components by repeating the steps in reverse •
order and tighten them using the appropriate torque (see table).
Type Torque
DGC-8-…-G 2.0 Nm ±20%
DGC-12-…-G 2.0 Nm ±20%