Festo DGC G Series, Repair Instructions

Page: 71 / 136

23 / 44 Festo 7DGC-GFa_en
DGC-32-…-GF and DGC-40-…-GF (not shown in the illustration):
Place the washers on the socket head screws, apply Loctite 243 to them and •
tighten them using the appropriate torque (see table).
Type Torque
DGC-32-…-GF 4.5 Nm ±10%
DGC-40-…-GF 4.5 Nm ±10%
Place the cover on the slide-piston connection and press it lightly so that it •
latches into place.
Grease the sealing rings and insert them into the end caps. •
Apply Loctite 243 to the self-tapping screws. •
Attach the end caps to both ends of the cylinder barrel. •
Screw the self-tapping screws into the cylinder barrel through the end cap •
and attach them loosely so that the end caps can still be shifted.
Align the rear and bottom edge of both end caps flush with the cylinder •
barrel.
Tighten the self-tapping screws on both ends using the appropriate torque
•
(see table).
Type Torque
DGC-18-…-GF 7 Nm
DGC-25-…-GF 12 Nm
DGC-32-…-GF 30 Nm
DGC-40-…-GF 30 Nm
Note
After the linear drive has been assembled, it needs to be commissioned as
described in chapter 7 of the operating instructions.