4
Commissioning
Festo – P.BE-CPX-FB37-EN – 1406NH – English
33
Manual configuration
Manual configuration is also possible as an alternative. Here the connected CPX modules are selected
from a module list in the configuration interface.
Fig. 4.5
Manual configuration of the CPX terminal
Adding the bus node
Select the bus node in the configuration and programming software and specify the following:
–
the mode in which you want to operate the bus node
–
whether, and in what format, the diagnostic messages of the CPX terminal are to be used.
The following options are available:
Module designation
1)
Operating mode
CPX diagnostics
FB37-RIO-EtherCAT Remote I/O
Remote I/O
No CPX diagnostics
FB37-RIO-EtherCAT Remote I/O [ST]
Remote I/O
Display of common
diagnostic messages
FB37-RIO [STI] -EtherCAT remote I/O
Remote I/O
All diagnostic information is
available
FB37-RC [8 bytes IO]
Remote controller
8 byte I/8 byte O for
communication of the bus
node with the CPX-FEC or
CPX-CEC
–
1)
Module designation in the configuration and programming software