43
RECEPTION AND POSITIONING
Part. 3
4
Fig. 1
Inspections on arrival
As soon as the appliance is consigned, it is essential to make sure that all the ordered items have been received and that the
shipment is complete. Carefully check that the equipment has not been damaged. If visible damage is discovered, immediately inform
the haulage contractor and write “Collected with reserves owing to evident damage” on the consignment note.
Delivery ex works means that, as established by law, reimbursement of any damages is at the insurance company’s charge.
Safety prescriptions
Comply with the current safety regulations concerning the equipment to use when handling the unit or the required ways of operating.
Use single protection devices as goggles, gloves, helmets… when handling the unit to avoid risk of injuries.
Handling
Check the weight of the appliance before proceeding with the moving and handling operations. The weight is indicated on the data
plate of the appliance and in the WEIGHTS AND CENTERS OF GRAVITY DURING TRASPORT AND OPERATION section of this
manual. Make sure that the appliance is handled with care and without jolting as rough treatment could damage the functional parts
of the machine.
Comply with the following instructions when lifting and positioning the appliance:
• Handling and lifting with a crane or similar
1) Using the brackets (Part 1 Fig.1) located by the lifting holes (refer to part 3 in the “Dimensional data”
section).
2) Position metal pipes (Part 2 Fig.1) of adequate thickness in the holes in the base of the unit for lifting.
• The end portions of the pipes must stand out by an adequate extent to permit inserting the safety devices and housing the belts for
lifting.
• Use spacer bars in the top of the unit to prevent crushing and damaging the batteries and the parts intended to cover the assembly.
• Consult the WEIGHTS AND CENTERS OF GRAVITY DURING TRASPORT AND OPERATION section for the center of gravity
position.
NOTE: To correctly lift the machine, the belts used must be longer than 3.5 meters.
Refer to the data plates (Part.3 Fig.1) that identify the center of gravity position, applied to the 4 sides of the base.
Use protections on edges (Part.4 Fig.1) to void risk of damages.
wARNING:
To safeguard persons and property, read the information on the packing that covers the unit before handling. Also make sure to:
• Handle the machine with care
• Do not stack other objects on top of the unit
4
Summary of Contents for RHA series
Page 71: ...71 ...
