10
ACCESSORIES AND OPTIONAL EQUIPMENT
NOTE:
The accessories can be of the following type:
(M):
only installed in the factory.
(F):
supplied for installation by the customer.
SAA- Water Storage tank (M).
Painted steel water storage tank reduces compressor startup frequency and temperature fluctuation
on water side. It is coated with thermo insulated material to avoid air condensing and losses due to heat transfer. It is available on
delivery side and also for primary-secondary hydraulic circuit interface.
Water storage tank. It consists of:
water draining.
On-off action by means of a cock that can be accessed by removing the rear panel, positioned on the side of the
unit opposite to the electric panel.
Air vent.
Accessed by removing the rear panel positioned on the side of the unit opposite to the electric panel. It consists of a
manually operated valve installed on the highest part of the wet pipes.
Antifreeze heater connection.
1”1/4 female threaded connection pre-engineered for installation of the antifreeze heater (RAG ac
-
cessory).
water safety valve
, on the rear part of the tank. It acts whenever faulty service leads to an operating pressure in the hydraulic
circuit that exceeds the valve opening value.
KT -
the following kits are available:
- Victaulic connection kit
(F).
This accessory consists of steel pipes insulated with thermal barrier material and allows the water
inlet/outlet to be connected straight inside the unit.
- Complete pipe kit
(M).
This accessory consists of steel pipes insulated with thermal barrier material and allows the water inlet/
outlet connection to be routed to the machine.
- Water storage tank pipe kit
(M).
This accessory consists of steel pipes insulated with thermal barrier material and allows the
water inlet/outlet connection to be routed to the machine.
NB: YOU CAN CHOOSE ONLY ONE KIT.
GP- Coil protection grid (M).
Protects external surface of the finned coils.
GM- Pressure gauges kit (M).
4 pressure gauges allow visualization of high and low refrigerant gas pressure.
AVG- Rubber vibration dampers (F).
Reduce vibrations transmitted to the floor by compressors and fans during normal operating
conditions (until 85%).
AVM- Spring vibration dampers (F).
Reduce vibrations transmitted to the floor by compressors and fans during normal operating con-
ditions (until 90%).
Summary of Contents for RHA series
Page 71: ...71 ...
