Ferroli OMNIA HYBRID C, Installation, Maintenance And User Manual

Page: 61 / 116

61
EN
Cod. 3541T090 - Rev. 00 - 06/2019
REMOTE CONTROLLER - SERVICE MENU
When selecting HEAT MODE is OK, the unit is forced to operate in HEAT MODE
and the page opposite appears on the display.
During this function the water setpoint (T1S) is equal to 35 ° C. After 10 minutes
of compressor operation the first stage of the electric booster (IBH1) is activated,
after 60 seconds the second stage of the electric booster (IBH2) is activated, after
3 minutes IBH1 and IBH2 are turned off. The unit then continues to operate until
the setpoint is satisfied or until the next command is received.
11 MODO TEST
Modo test attivo.
Modo caldo attivo.
Temperatura uscita acqua 15 °C.
CONFERMA
OK
fig. 148 -
When you select DHW MODE is OK, the unit is forced to operate in DHW mode
and the page opposite appears on the display.
During this function the water cas setpoint (T5S) is equal to 55 ° C. After 10 minu-
tes of compressor operation the ACS electric support heater (TBH) is activated.
After 3 minutes TBH is switched off and the unit continues to operate until the
setpoint is satisfied or until the next command is received.
11 TEST RUN
Test run is on.
DHW mode is on.
Water flow temper. is 45°C
Water tank temper. is 30°C
CONFIRM
OK
fig. 149 -
During test run, all buttons except OK are invalid. If you want to turn off the test
run, please press OK. For example ,when the unit is in air purge mode, after you
press OK, the page will displayed as follows:
11 TEST RUN
Do you want to turn of the
test run(air purge) function?
SCROLL CONFIRM
OK
NO YES
fig. 150 -
Use ◄ ► to scroll the cursor to YES and press OK. The test run will turn off.