26
5. Before using the equipment
Before you connect the equipment to the
power supply make sure that the data on
the rating plate are identical to the supply
voltage.
Warning!
Always pull out the power plug before
making adjustments to the equipment.
Assembly
WARNING! Risk of injury!
If you assemble the bench-type circular
saw incorrectly, this could lead to serious
injuries.
Assemble the bench-type circular saw cor-
rectly and completely, including all covers
and safety devices, before using for the fi rst
time.
•
Never under any circumstances insert
the power plug into the socket outlet
before completion of assembly.
Fitting the legs. (Fig. 5-11)
1. Turn the saw table (1) over and set it
down on the fl oor.
2. Fit the four legs (8) loosely to the saw
table with the help of two hexagon
screws (25) and two large washers (28)
for each leg.
3. To do so, use the drill holes provided in
the saw table and the threaded sockets
in the legs.
4. Then fi t one middle strut (9) between
each of the legs by inserting the faste-
ning opening at the ends of the middle
strut into the detents on the legs and
pressing them so that they lock into
place.
5. Secure the middle struts to the legs
using two lock bolts (23), two small
washers (27), two spring washers (24)
and two hex nuts (29) on each.
6. Now tighten all the screw connections.
7. Then plug one rubber foot (11) onto
each leg (8).
8. Then fi t one tilt guard (10) to each of
the rear legs using two hexagon screws
(24), spring washers (26), small was-
hers (27) and hex nuts (29) each.
Fitting the table width extension
(Fig. 12)
1. To be able to fi t the table width exten-
sion (7), remove the screw (A) on both
undersides of the guide tubes.
2. After undoing the two knurled screws
(30), you can slide the table width ex-
tension into the opening.
3. Now fi t the screw (A) back in the guide
tube. This serves as an end stop.
F_TS_2000_1_GB_SPK7.indb 26
F_TS_2000_1_GB_SPK7.indb 26
04.06.2019 10:19:01
04.06.2019 10:19:01
