28
front end.
12. Check that the table insert is secure: The
table insert must be fl ush with the saw
table.
13. Secure the table insert using the two
fastening screws.
Fitting the parallel stop (Fig. 21)
1. Slide the stop rail (22) onto the parallel
stop (20) so that the square necks of the
two lock bolts slide into the profi le of
the stop rail.
2. Secure the stop rail on the parallel stop
by tightening the two knurled nuts.
3. Place the parallel stop with open ec-
centric lever (35) on the rail (36) on the
saw table.
4. To change to position of the parallel
stop, move the parallel stop with open
eccentric lever to the right or left.
5. Press the eccentric lever completely
down to secure the parallel stop in the
desired position.
Connecting a vacuum extraction device
(Fig. 22)
•
The dust extraction connector (37) is
located on the back of the bench-type
circular saw.
•
Connect the suction hose of a suitable
chip extraction system (e.g. a multi-
purpose vacuum cleaner) to the dust
extraction connector (37) and secure
it with, e.g. a hose clip. Please note: A
normal household vacuum cleaner is
not suitable to be used as a vacuum
extraction device in this case.
6. Operation
Setting the cutting depth
Use the crank (32) to turn the saw blade
(31) out of the saw table (1) and lower it
into the saw table. Adjust it to the depth you
require as follows:
•
Increasing the cutting depth:
Turn the crank clockwise so that the saw
blade is moved out of the saw table.
•
Reducing the cutting depth:
Turn the crank counterclockwise so that
the saw blade is lowered into the saw
table.
Setting the cutting angle (Fig. 23)
1. Turn the locking screw (38) approx. one
revolution counterclockwise to slacken
it.
2. Use the crank wheel (39) to adjust the
cutting angle to the angle you require
on the angle scale (40).
3. Turn the locking screw clockwise to
tighten it and secure the saw blade (31)
F_TS_2000_1_GB_SPK7.indb 28
F_TS_2000_1_GB_SPK7.indb 28
04.06.2019 10:19:01
04.06.2019 10:19:01
