30
Rule of thumb: The rear end of the stop
comes up against an imaginary line that be-
gins roughly at the center of the blade and
runs at an angle of 45° to the rear.
1. Set the required cutting width.
2. Slacken the knurled nuts on the parallel
stop (20) by turning them several revo-
lutions.
3. Move the stop rail until the rear end of
the stop rail touches the imaginary 45°
line.
4. Tighten the knurled nuts again.
Cross stop
Do not push the stop rail of the cross stop
too far toward the saw blade. The distance
between the stop rail and the blade should
be approx. 2 cm.
1. Slide the stop rail (17) onto the cross
stop (15) so that the square necks of the
two lock bolts slide into the profi le of
the stop rail.
2. Secure the stop rail on the cross stop by
tightening the two knurled nuts.
3. Slide the guide rail system (18) of the
cross stop into the guide grooves (6) of
the saw table.
4. Slacken the knurled screw (16) and turn
the cross stop until the line on the guide
rail system coincides with the required
angular setting.
5. Tighten the knurled screw again.
Laser (Fig. 24)
With the help of the laser (3), you can
perform precision cutting work with your
bench-type circular saw. The laser light is
generated by a laser diode. The laser light
is enlarged to form a line and is emitted
through the laser emission aperture. You can
then use the line as an optical marker of the
sawing line for precision cuts. It is important
that you obey the safety instructions for the
laser.
Switching on the laser:
Set the laser switch (41) to “ON”.
When the saw blade guard is fi tted, the
laser switch can be accessed through the
opening on the top. A red laser beam will
now be projected from the laser emission
aperture. If you guide the laser beam along
the sawing line mark as you saw, you will
produce clean, precise cuts.
Switching off the laser:
Set the laser switch (41) to “OFF”.
The laser beam will go out.
Always switch off the laser when not in use
in order to save the batteries.
The laser beam can be blocked by deposits
of dust and chips. You should therefore
F_TS_2000_1_GB_SPK7.indb 30
F_TS_2000_1_GB_SPK7.indb 30
04.06.2019 10:19:01
04.06.2019 10:19:01
