31
remove these particles from the saw blade
guard each time after use.
Inserting/changing the laser batteries
(Fig. 11)
The laser beam shows you exactly where
the saw blade (31) will be cutting next and
therefore enables you to achieve extremely
precise cuts. For the operation of the laser
(3) you require two type 1.5 V
AAA/
LR03 batteries (supplied with the product),
which are inserted/changed as follows:
1. Set the laser switch (41) to position 0
(laser off ).
2. Swing the saw blade guard (2) up as
shown in Fig. 24.
3. Flip the battery compartment cover
(42) up and remove it.
4. Remove the old batteries from the bat-
tery compartment if necessary. Please
observe the instructions in the section
“Disposal”.
5. Insert the new batteries, ensuring
that you fi t them the right way round
according to the polarity shown in the
battery compartment.
6. Replace the battery compartment cover.
7. Swing the saw blade guard (2) down
again.
Switching the bench-type circular saw on
and off
WARNING! Risk of injury!
If the bench-type circular saw has been
assembled incorrectly, this could lead to
serious injuries.
•
Assemble the bench-type circular saw
correctly and completely before using
for the first time.
•
Before you switch on the bench-type
circular saw, make sure that the saw
blade is correctly fitted and that the
equipment‘s moving parts run smoo-
thly.
•
Press the green operating switch I (43)
to switch on.
The motor starts. Wait for the saw blade
(31) to reach its maximum speed of
rotation before starting sawing.
•
To switch off the bench-type circular
saw, press the red operating switch 0
(43).
Caution:
The saw blade continues to run for
quite a while. Do not leave the bench-type
circular saw until the saw blade has come to
complete standstill.
F_TS_2000_1_GB_SPK7.indb 31
F_TS_2000_1_GB_SPK7.indb 31
04.06.2019 10:19:01
04.06.2019 10:19:01
