FENIX IMVICO
TK23 OPERATION MANUAL
31/81
3.4.2- PROGRAMMING MODE
The TK23 has a PROGRAMMING MODE in order to set up some parameters of the
printer, without sending any command. In this mode, the printer makes some questions
to the user. These questions must be answered by pressing one of the two push
buttons.
PFEED button means “YES” and “PROG” button means “NO”.
Fig. 3.5-
Programming buttons.
NOTE - You can use the in-board push buttons: SW1 is PFEED and SW2 is PROG
Starting the programming mode:
To start the programming mode, turn off the printer, and hold down the PROG button
then turn on the printer. Then the printer asks for the configurable parameters.
These are the configurable parameters during PROGRAMMING MODE:
•
Mechanism:
LTP2242 series at 60mm, LTP2342 series at 80mm or
LTP2442 series at 112mm (total cutter or partial cutter).
•
Baudrate:
4800, 9600, 19200 or 38400 baud.
•
Parity for serial transmission: ODD, EVEN, NO PARITY.
•
Head Activation: 1 strobe (fixed mode) or 2 strobes (dinamic mode).
•
Print density:
Light (-50%), Normal or Dark (+50%).
•
Black Mark:
Enable / Disable marked paper.
•
Carry Return:
Enable / Disable CR command.
YES
NO
"PFEED" button
"PROG" button
