FENDT FORMER 12545 PRO, Operator'S Manual, Page: 54 / 76

Using the machine
52 FORMER 12545 PRO
The working width is changed by retracting
or extending the hydraulic cylinders on the
two front swivel arms.
The working width is infinitely adjustable
between 10.60 m and 12.50 m.
 Select the "Working Setup" menu
 Press the "Increase work-
ing width" button until the
desired working width is
set.
 Press the "Decrease work-
ing width" button until the
desired working width is
set.
7.7.3 Adjusting working height
The working height is set using the "Work-
ing Setup" menu.
Adjust the working height only as low as is
required for tidy raking.
 Select the "Working Setup" menu
 Press the following buttons until the de-
sired working height is set.
Button Working height
Increase
working
height Increase the
working height
of all rotors sim-
ultaneously
Decrease
working
height Decrease the
working height
of all rotors sim-
ultaneously
Increase Increase the
working height
of the corre-
sponding rotor
Decrease Decrease the
working height
of the corre-
sponding rotor
7.7.4 Adjusting the height of the
swath former
WARNING
Risk of injury from moving machine
parts
Unwanted movement of the machine may
occur in the course of adjustment work.
Unless otherwise prescribed in this Oper-
ator's Manual, proceed as follows:
 Apply the tractor parking brake.
 Switch off the tractor engine.
 Remove the ignition key.
 Secure the machine and tractor against
rolling away.
The height of the swath former is set via
the position of the spacer.
The swath former can be mounted at two
heights.
Adjusting the height of the swath for-
mer
Spacer position Altitude
Under the swath cloth
holder High
Above the swath cloth
holder Low
 Loosen the nut (1).
 Pull the spacer (2) and the swath cloth
holder (3) off the screw (4).
 Place the spacer and the swath cloth
holder onto the screw in the appropriate
order for the desired position.

Secure this adjustment with the nut.