NOTES
Light pressure: as an example consider an operation to cut a full steel bar (e.g. C40, D.
50 mm). This should be carried out in about 4 minutes. Once the blade has been run in,
the same kind of workpiece can easily be cut out in about 2 minutes.
5.2.
LUBRICATION
NOTES
The tool does not need lubricating.
5.3.
CLEANING - TASKS TO BE PERFORMED
DANGER - WARNING
- BEFORE COMMENCING CLEANING OPERATIONS, PUT ON ADEQUATE
PERSONAL PROTECTIVE EQUIPMENT (SAFETY GLASSES, GLOVES AND
MASK TO PROTECT THE AIRWAYS).
- AVOID USING JETS OF COMPRESSED AIR.
When necessary:
1. Remove any work residues from around the work area and surfaces using a small brush
or vacuum cleaner.
2. Disassemble and clean the extractor fi lter (optional) by tapping it.
Every day:
Remove any work residues and dust from the whole machine, including the power cable, using
a vacuum cleaner or a small brush.
Once a week:
Disconnect the exhaust fi lter or conduit and thoroughly clean the extractor (optional).
5.4.
CHECKS
Every day:
1. Check that the power cable is in tact.
2. Check that all guards are intact.
3. Check that the tool is intact and shows no signs of wear.
5.5.
STORAGE OF THE MACHINE WHEN NOT IN USE
When the machine is not in use, place it in safety conditions as described in the heading
“GENERAL SAFETY REGULATIONS”.
5.6.
ASSISTANCE
If the intervention of expert personnel is required to perform extraordinary maintenance
operations or repairs, always contact an authorized after sales service.
5.7.
DISPOSAL OF THE MACHINE, PACKAGING AND MATERIALS PRODUCED BY
MAINTENANCE OPERATIONS
The machine and its packaging are made from 100% recyclable materials.
The electrical and electronic components (indicated by a crossed out wheelie bin symbol) must
be disposed of in accordance with Directive 2012/19/EU.
33
EN
Summary of Contents for NG120XL
Page 2: ......
