Specific characteristics of the electrical system
DANGER - WARNING
- THE SAW’S ELECTRICAL SYSTEM IS FITTED WITH AN UNDER-VOLTAGE
RELAY WHICH AUTOMATICALLY OPENS THE CIRCUIT IF THE VOLTAGE
DROPS BELOW A MINIMUM SET LIMIT AND INHIBITS AUTOMATIC RESET
OF OPERATING CONDITIONS WHEN THE VOLTAGE RETURNS TO THE SET
RATED LEVELS.
- SHOULD THE MACHINE SUDDENLY CUT OUT THERE IS NO CAUSE FOR
ALARM. CHECK THAT THERE HAS NOT BEEN A VOLTAGE FAILURE IN THE
MAINS SUPPLY.
3. ADJUSTMENTS
DANGER - WARNING
- PLACE THE MACHINE IN SAFETY CONDITIONS AS DESCRIBED IN THE
HEADING “GENERAL SAFETY REGULATIONS”.
- WEAR PROTECTIVE GLOVES.
- ALL THE PROCEDURES FOR MACHINE ADJUSTMENTS AND USE DESCRIBED
IN THE FOLLOWING HEADINGS MUST BE PERFORMED ONLY AFTER THIS
INSTRUCTION, USE AND MAINTENANCE MANUAL HAS BEEN READ AND
UNDERSTOOD IN FULL.
DANGER - CAUTION
- At the end of every adjustment operation, check that all fasteners are securely
tightened.
- At the end of every adjustment operation make sure no tools have been left on
the machine.
3.1.
ADJUSTING BLADE TENSION (Fig. 4A - 4B)
Turn the handwheel (2) clockwise until the clutch engages.
DANGER - WARNING
- IF THE TENSION IS TOO HIGH THE BLADE MAY JUMP OUT OF THE
GUIDES
3.2.
CUTTING ANGLE - HEAD ROTATION ADJUSTMENT (Fig. 6A - 6B)
NOTES
Depending on the model, the machine is supplied with a basic 0° and 45° setup (with
mechanical stoppers 23, 25) or 0°, 45° and 60° setup (with mechanical stoppers 23, 25
and quick set feature at 45° by turning knob 26 up.
DANGER - WARNING
TO CHECK OR MODIFY CALIBRATIONS, PLEASE CONTACT AN AUTHORIZED
AFTER SALES SERVICE CENTRE.
Cont....
28
EN
Summary of Contents for NG120XL
Page 2: ......
