Page | 53
User Manual – FELIX Pro 1
Rev 3
www.FELIXprinters.com
[email protected]
This could cause buildup of filament in some internal cavities/edges.
16.4
Z-sensor triggered.
This message normally is shown when the printer detects that one of the nozzles is touching the heated
bed (we call that functionality "Z probing").
It can also be shown when the print head is cooled down while there is filament in the printer.
The filament shrinks when it cools, and then pulls up the print heads a bit. This is detected by the printer.
The message does not need to be a problem. Usually it disappears if both of the print heads are heated to
150 degrees C or more. The plastic in the extruders then becomes soft again, allowing the heads to return
to their normal position.
The printer will heat the heads automatically when it needs the Z probing functionality.
If you still experience problems after the heads have been warmed up the next section.
