Page | 48
User Manual – FELIX Pro 1
Rev 3
www.FELIXprinters.com
[email protected]
14.2
Print bed contact points
Make sure to keep the contact points on the bottom of the print bed clean. Use a detergent like alcohol
and rub gently with a paper towel or cloth. Check this regularly, especially, when you remove the bed a lot
from the printer.
14.3
Dust cleaners
Filament attracts a lot of dust and small particles. Make sure the filament enters the filament holder
through the dust cleaner. After a few months of printing it is recommended to replace the dust cleaners.
14.4
Motion system
The linear bearings require almost no maintenance. Recommended is that you put a little some grease on
them every 3-4 months.
The belt tension of the x and y axis can also be checked in intervals of 3 months. Check this small movie
to see how to tension the belts.
https://www.youtube.com/watch?v=dpS6nWn5rE8
Make sure the four
contact pads are clean
from grease or debris
