Page | 19
User Manual – FELIX Pro 1
Rev 3
www.FELIXprinters.com
[email protected]
7.5
Load the filament
After setting heater temperatures, you can load the filament into the printer.
From previous step you have guided the filament
through the guiding tube and the filament guide.
The plastic that comes out of the tube it is
recommended to cut off the end in a skew manner
and throw the just cut off debris away.
Insert the filament into the left opening on top of
the extruder.
Push the filament in and rotate the button
clockwise until the filament is automatically pulled
in.
Keep rotating until a small thread comes out of the
extruder. Use the supplied tweezers to remove this
thread.
