Page | 16
User Manual – FELIX Pro 1
Rev 3
www.FELIXprinters.com
[email protected]
7.2
First checks
Due to shipping it could happen that the electrical contacts of the probe-mechanism inside the
removable hot-ends are slightly loosened. To ensure this is not the case, please do the following.
1.
Open front flap
2.
Pull out hot-end a few mm, by pulling on the aluminum flange of the hot-end, and firmly push it
backwards again to ensure the electrical contacts inside the hot-ends are properly connected.
3.
When the printer is turned on, please make sure the status message z-sensor triggered!! Is not
shown in the main menu.
1
2
