Felisatti SG6/750, Operating Instructions Manual

Page: 7 / 41

7
metals.
Fine toothing: hard steels, hardened steels.
Felt Wheels (C)
These require paste for polishing.
Valve grinding, shiny inishing of ground or polished
surfaces.
Fans (D)
Dies and moulds and light deburring work.
Wire Brush (E)
Steel wire: for cleaning rusty surfaces.
Brass wire: for matt surfaces.
Stainless steel wire: for stainless steel items.
NOISE AND VIBRATION
This tool has been designed and made to reduce
noise to a minimum. However, in spite of this, in certain
circumstances the maximum noise level in the place
of work could exceed 85 dBA. In this case, the operator
should wear ear protection.
The machine’s noise and vibration levels, measured in
compliance with EN60745-1, usually reach:
Acoustic pressure = 85 dB(A)
Sound-power level = 98 dB(A)
Use ear protection!
Vibration acceleration = 2.5 m/s
2
ACCESSORIES
Accessories and their corresponding order number
can be found in our catalogues.
MAINTENANCE AND CARE
WARNING! Always unplug the machine before
carrying out work on it.
- Inspect the tool: Using a worn deburring or cutting tool
will diminish the eficiency of the work and could damage
the motor.
- Inspect the mounting screws: Regularly inspect all
the mounting screws and ensure they are irmly tightened.
Should any screw be loose, tighten it immediately. Failure
to do so could put you at serious risk.
- Motor maintenance: Always take the greatest care
over this and make sure that the motor winding is not
damaged and does not become wet with oil or water.
- The vents should always be kept clean and free of
obstacles.
- Clean the machine thoroughly after each use. Blast
the motor regularly with compressed air.
- Check that the mains lead is in good condition. If it is
not, take it to an Oficial Service Centre to have it replaced.
- Brush replacement: The brushes should be replaced
after 150 - 200 hours use or when they are less than 10
mm long. Have this done by an Oficial Service Centre. We
recommend that at every second change of brushes, you
take the machine to one of our Oficial Service Centres for
general cleaning and oiling.
- Use only
FELISATTI
accessories and spares. Parts
the changing of which is not covered in this instruction
manual, should be replaced in a
FELISATTI
Oficial
Service Centre.
WARRANTY
See general warranty conditions printed on the
attached sheet.
DISPOSAL
WARNING!
Do not dispose of electric tools in the
household waste!
In accordance with European Directive 2002/96/EC
relating to old electrical and electronic appliances and
its translation into national law, used electric tools must
be collected separately and recycled in an ecologically
desirable way.