TST
Assembly instructions
FUF2 / FU3F-A/-C/-F
FEIG ELECTRONIC GmbH
Page 13 of 114
TST_FUxF-A-C-F_Montageanleitung_EN_15
2
Safety instructions
Failure to observe the safety advisories can result in physical harm or damage to the
controller.
When starting up and operating the controller, the following important safety advisories as
well as the installation and wiring notes must be strictly observed:
In accordance with the EC Machinery Directive only qualified personnel shall install the
device on the doors or at the drive units for doors or bring them together.
The respective
safety requirements for the entire door (machine) must be aligned with the possibilities to meeting
these safety requirements on the controller.
Improper integration of the controller into the door complex
–
e.g. missing sensors, incorrect
parameters, speed set excessively high, etc.
–
presents the risk that the door is operated without
adequate safety precautions.
A position encoder certified for PL "c" must be used to comply with the safety function
according to EN 13849.
The start up of this controller is prohibited until it has been properly attached to the door
that conforms with the EC Machinery Directive and for which an EC declaration of
conformity according to Annex II of the Directive was obtained.
The following information describes standard applications that may not necessarily match the
actual application. The actual application is provided by the manufacturer of the door as part of the
overall documentation or as part of the
operating instructions
of the door.
Any installation, commissioning and maintenance work must only be performed by
qualified specialists.
In particular, the following regulations must be observed: VDE0100, EN
50110 (VDE0105), EN 60204 (VDE0113), EN 50178 (VDE0160), EN 60335 (VDE0700), fire
protection codes, accident prevention regulations as well as the relevant regulations for industrial
doors and machine safety standards (EN ISO 13849, EN 62061)(ZH1/494, EN12453, EN12978)
This device is not intended for use by persons (including children) with limited physical, sensory or
mental abilities or with a lack of experience and / or knowledge, unless they are supervised by a
person responsible for their safety or if they have received instructions on the use of the device.
Children should be supervised to ensure that they do not play with the device. Keep remote
controls away from such persons.
Device identification (nameplate with information on name and address of manufacturer, serial
number, year of construction, type designation, supply voltage and temperature range) must be
carried out at the latest after installation.
The example of the warning label must be attached to the motor near the motor terminal board.
