TST
Assembly instructions
FUF2 / FU3F-A/-C/-F
FEIG ELECTRONIC GmbH
Page 16 of 114
TST_FUxF-A-C-F_Montageanleitung_EN_15
4
Installation of the controller
IMPORTANT INSTRUCTIONS FOR SAFE INSTALLATION!
Observe all instructions; incorrect installation can result in serious injuries!
•
When installing the controller, the system must be turned off.
•
The controller may be opened only if all the poles of the supply voltage have been turned off. It
is not permitted to turn on or to operate the controller when it is open.
•
Disconnect all supply circuits before opening the housing for access to the terminals.
•
Before the installation, check the controller for transport or other damages. Under some
conditions a damaged controller may result in significant consequential damage to the controller
as well as hazards to the user.
•
The controller must never be operated with a damaged membrane keypad or Display window.
Damaged keypads and Display windows must be replaced.
•
Do not touch any electronic parts, in particular the components of the processor circuit.
Electronic components can be damaged or destroyed by electrostatic discharge.
•
Before opening the cover of the housing, ensure that no drilling swarf can fall into the housing
from the cover.
•
When installing the controller it is important to ensure that it is not subject to mechanical
stresses.
•
Unused cable entries must be sealed to maintain the requirements of IP65.
•
Ensure that the cable entries are not subjected to mechanical stresses, in particular tensile
stresses.
•
The controller must never be operated without the CEE-plug except when the supply voltage
can be cut all poles by an installed main switch. The main switch and the CEE-plug must be
within easy reach.
•
A not rotating motor is no indication of the galvanic isolation from the power grid! The mains
connection terminals, motor terminals and terminals for the brake resistor can still carry
dangerous voltages, e.g. under stop or emergency stops.
•
If the supply cable is damaged, it must be replaced by the manufacturer or another qualified
person in order to avoid danger (like connection type Y EN 60335-1)
•
When moving the door in deadman mode, ensure that the operator has an unobstructed view of
the door area. In this mode, safety equipment such as safety edge and photo eye may have
been defeated. If this is not possible for structural reasons, you must ensure that this mode is
only accessible to appropriately trained personnel or that the feature is disabled altogether.
•
To prevent damage to the keypad, do not use pointed objects to operate the keys. The keypad
is only designed to be operated by human fingers.
•
Depending on the type of the door it may be necessary that the door can only be operated when
it is within visual range. In these cases, no remote control (e.g. wireless) may be used to issue
commands.
•
It is important to ensure that the controller is installed with the wall spacers that are supplied to
guarantee that the power stage can dissipate heat as necessary.
•
The control unit should not be mounted on flammable surfaces (e.g. wood ≤ 2 mm thickness) or
in environments with highly flammable substances (e.g. carpentry).
•
When the controller is installed in an additional housing, e.g. in a barrier housing, care must be
taken to provide a sufficient volume of air around the controller. This must be at least 0.02 m
3
.
