Feig Electronic TST FUF2 Series, Assembly Instructions Manual

Page: 99 / 114

TST Assembly instructions FUF2 / FU3F -A/-C/-F
FEIG ELECTRONIC GmbH page 99 of 114 TST_FUxF-A-C-F_Montageanleitung_EN_15
No. Description
I.520
Target speed for opening or closing move not reached
•
Pre-limit switch reached before full speed was reached --> adjust ramps
•
Current limiter prevents movement at full speed --> Inverter or motor working at performance limit --> adjust ramps or limiter
I.555
Measuring rotation factor not ready
I.610
Light line alignment completed successfully.
I.615
Light curtain light line alignment start
I.616
The second light line alignment wit normal drive speed is active
I.621
The resolution of the installed position encoder is too low to maintain robust light curtain operation.
More increments are required per door move. (Message only occurs when DIP-Switch is ON.)
I.700
In timer limit switch operating mode (typ. after power on) the door position is not available. Deadman speed is maintained until the
actual position becomes available again.
I.856
No door movement possible
I.901
Wait for USB-stick
I.902
The startup mode can be between 0 ... 31 seconds depending on the configuration.
I.903
Can not open File
I.906
Update File has the wrong format
I.907
The boot loader can be started, the controller expects the users input
I.916
Error reading USB stick (data storage)
•
SPI or USB communication faulty
•
USB stick write protected, memory full or formatted with an unknown file system
I.917
Log function is being initialized. The controller is halted until the initialization is complete.
I.919
The controller will shut down after a user reset (3-finger reset)
I.941
The Paramterfile can not be written because there were no free Directories found
I.942
The Paramterfile can not be written because the storage device is full
I.943
The Paramterfile can not be written because the storage device is write protected
I.944
The Paramterfile can not be written because the file is write protected
I.945
The Paramterfile can not be loaded because there was no file founded
I.946
The Paramterfile can not be loaded because the file is faulty or the key is unknown