
Install smaller tank in front of large tank (see photo).
Fuel should flow from the large tank to the smaller
tank and then to the air trap or pump.
Cut a piece of scrap ply approximately 1/2 inch by 6
3/8 inch. Bolt in place to the formers at the top of the
small tank to keep it from moving upwards in flight.
Remove tanks, and re-plumb lines if necessary.
Reinstall tanks and hold down ply. Drill a hole in the
lower right side for the vent fitting (not supplied) and
connect line.
Using wire tie as shown, clamp small tank to ply hold
down to keep it from shifting forward in flight.
Now would be a good time to fill the system and check
one last time for leaks. When completed, plug the
lines to keep the kero from leaking as you finish work
on the airframe.
FEI BAO T45
14