Sweep
Press the
SWEEP
key on the front panel to enable the scanning function, and
fy6200 can output the scanning waveform from ch1 channel.
The process of
gradient scanning for a specific parameter object at a specified time from the initial
value to the termination value.
For sine wave, square wave, sawtooth wave and
arbitrary wave, scanning output can be generated.
2-2 Sweep parameter setting interface
Sweep Object
The FY6200 can output sweep waveforms from the CH1 channel. The
parameters that can be scanned are: frequency, amplitude, offset, duty cycle.
Switching object types can be switched via the
OBJE
soft key.
⚫
In the frequency scanning mode, the signal generator changes the output from
the starting frequency to the ending frequency within the specified sweep time.
⚫
In the amplitude scanning mode, the signal generator changes the output from
the starting amplitude to the ending amplitude within the specified scanning
time.
⚫
In the offset scanning mode, the signal generator changes the output from the
start offset to the end offset within the specified scanning time.
⚫
In duty cycle scanning mode, the signal generator changes the output from
the start duty cycle to the end duty cycle within the specified scanning time.
