FM
、
PM
Sine, square, sawtooth and arbitrary waveforms can
be scanned.
—
Supports scanning of four parameters of
frequency, amplitude, offset, and duty cycle.
—
Supports two linear and logarithmic scanning
methods.
Can switch to frequency meter and counter function,
measure frequency, period, duty cycle, positive pulse
width of external input signal.
—
Supports DC and AC signal input
—
Supports 1 s, 10 s and 100 s gate time switching.
—
Dual channel output can work with frequency
meter measurement.
VCO function can be set
—
Support VCO voltage control signal generator's
frequency, amplitude, offset, duty cycle and other
parameter output functions (such as voltage-
controlled oscillator).
Used to set auxiliary function parameters and system
parameters.
—
Supports storage of 20 sets of parameters such as
frequency, amplitude, offset, and phase
—
Support Chinese and English switching
—
Support prompt tone off/on
—
Supports multi-machine cascading
—
Supports master/slave switchover in cascaded
state
—
Supports dual-channel power-on default output
state setting
4
Direction key
When the knob is used to set parameters, it is used to move the
cursor to select the bit to be edited.
5
Adjusting knob
When using the knob to set parameters, you can increase (clockwise)
or decrease (counterclockwise) the value at the current cursor.
6
Power button
The power indicator will remain on when it is turned on.
When the signal generator is turned off, the indicator light will enter
the breathing lamp state and CH1 and CH2 will stop outputting (the
output will remain at 0 volts).
7
CH1 channel
output
Connector
BNC connector, nominal output impedance 50Ω.
When channel CH1 is on (the CH1 button indicator lights up), the
connector outputs the waveform in the current configuration of CH1.
8
Channel
control,
Confirm button
It is used to control the output of the CH1 channel and
can be switched to the CH1 parameter setting interface
in any interface.
