Enable channel output
After completing the parameter settings for the selected waveform, you need
to turn on the channel to output the waveform. When the output is off, the LED
below the corresponding channel button is off; when the output is on, the LED is
lit.
The default CH1 and CH2 are enabled for output, and the LEDs under the CH1
and CH2 buttons are lit.
The power-on can also be set to the default off output state. Setting method:
Press the
【
SYS
】
button, and then press the
【
MORE
】
soft key to set the default
output status of the two channels.
⚫
To turn off/on the output on the CH1 channel, there are two states
：
1.
The signal generator works in the waveform parameter setting menu, and
the currently selected channel is
CH1
, Pressing the
CH1
button will switch
the output between off/on.
2.
The signal generator works in other function menus, or the selected
channel is not
CH1
，
Press
CH1
button once to make CH1
as the currently
selected channel. Press
CH1
again to switch the output between off/on.
⚫
To turn off/on the output on the CH2 channel, there are two states:
1.
The signal generator works in the waveform parameter setting menu, and
the currently selected channel is CH2. Pressing the
CH2
button will switch
the output between off/on.
2.
The current signal generator works in other function menus, or the selected
channel is not CH2. Press
CH2
once to take CH2 as the currently selected
channel, and press
CH2
again to switch the output between off / on.
