mr.steam
®
Installation, Operation & Maintenance Manual
_________________________________________________________________________
I
N
S
T
A
L
L
E
R
6
Drawings for illustrative purposes only.
Consult with qualified designer, architect or contractor
for steam room construction details.
Provide unions as required
to facilitate installation and
disconnect of piping
Steam
Generator
Field installed
power supply
Field installed
steam piping
Drain Valve must be
closed when the optional
AutoFlush is not installed
Control cable run in
1” conduit
(located
behind the wall)
Steam Head (shown with optional acrylic shield)
See page 9 for Steamhead Installation information
iSteam
®
, AirTempo
®
or
iTempo/Plus
®
Control
Refer to Control
Installation Manual
for installation
information
Field installed
water supply line
The control features an
integral temperature sensor. Locate the
control in a location representative of the
desired steam bathing temperatures. Do
not locate the control above or near the
steam head or direct steam emissions.
TYPICAL
MrSteam
INSTALLATION
When installing the optional AromaSteam,
install a downward facing 90-degree T in
the steam piping. See the AromaSteam
Installation Manual for complete information.
To avoid unintentional steambath operation, do not
locate the control where other controls, accessories, shower heads,
valves, body sprays or similar within the shower could cause confusion
or interfere with the MrSteam control’s intended use and function.
