mr.steam
®
Installation, Operation & Maintenance Manual
__________________________________________________________________________
H
O
M
E
O
W
N
E
R
CARE TIPS FOR ALL CONTROLS AND
STEAMHEADS
1. Use only mild soap and water on a soft cloth to clean
the control and steamhead.
2. DO NOT use abrasive cleansers.
3. If the decorative cover is damaged on the iTempo
or iTempo/Plus call MrSteam technical service for
replacement parts.
Replacement of the decorative covers requires
removal and reinstallation of the control from the mounting
surfaces.
STEAM GENERATOR MAINTENANCE
MrSteam steambath generators require little maintenance.
Other than periodic draining, maintenance procedures are mini-
mal. Every 2 months, or more often in “hard” water areas, the
manual drain valve should be opened fully flushing out accumu-
lated materials, salts and other particles which are natural by-
products of boiling water.
Flush a minimum of two-three hours after the con-
trol has been turned off to insure that the water has cooled.
Draining immediately after a steam cycle may
expose PVC and other piping to high temperature water. Check
local codes. The unit will refill automatically when the control is
activated again. In areas of hard water, a MrSteam AutoFlush
®
system is recommended for generator longevity.
Failure to allow the water to cool will expose the
equipment and user to scalding water and cause property and
personal injury.
IMPORTANT NOTE:
The model and serial number is printed on
the data plate on the front of the steam bath generator.
22
SETTING THE STEAM BATH
TEMPERATURE AND DURATION
Set the steam bathing temperature
according to personal preference, however it is highly rec-
ommended to begin steam bathing at a low temperature
setting to gauge comfort and safety levels. Set duration
to a maximum of 10 minutes to gauge comfort and safety
levels. This will allow the steam generator to heat up and
begin producing steam.
SAFETY AND OPERATING
INFORMATION
DO NOT install or use any iSteam
®
,
AirTempo
®
, iTempo/Plus
®
, iTempo
®
, HomeWizard
®
or
iGenie
®
controls without reading and understanding the
MrSteam steam generator Installation and Operation
Manual. Failure to read and understand these instructions
may result in an inoperative or hazardous installation.
The peel and stick warning sticker located
in this manual must be read and permanently affixed in a
conspicuous location near the steam room. Failure to read
and affix this warning sticker in a conspicuous location
may result in serious injury or death.
If an iSteam, AirTempo, iTempo or iTempo/Plus control is
installed outside the steam room a Remote Temperature
Probe (PN MSTS) must be installed inside the steam room
per installation instructions supplied with the Remote
Temperature Probe. Failure to install according to instruc-
tions will result in an inoperative control and
overheating of the steam room.
To prevent slip and fall hazards non-skip
strips must be installed on the steam room floor.
DO NOT alter or modify any MrSteam
product. Doing so may result in an inoperative or
hazardous installation and will void the UL listing and
warranty.
IMPORTANT NOTES:
Malfunction due to power spikes,
lightning, fire, freezing or flooding is not covered under
the warranty.
Discontinue use of the steam generator or control if the
steam generator is damaged or otherwise not functioning
properly. Doing so may result in an inoperative or
hazardous condition.
