If the generator is on for more
than a few minutes steam will start coming out
of the steamhead. Insure that steamroom is not
occupied.
STEP 5
Diagram 4
Remove and discard peel-off paper to expose
adhesive liner.
STEP 6
Diagram 5
Run a bead of silicone (provided) as shown to
the outer edge of the control faceplate,
following the contour of the circle or square
shape. Use silicone as required to create a
moisture seal.
NOTE:
The silicone supplied by Mr. Steam can
be used to meet a variety of sealing and
gasketing. It cures to silicone rubber and
adheres to glass, wood, metal, porcelain,
ceramic tile, painted surfaces, many plastics and
rubber. Surfaces must be clean and dry. Apply
thin layer of product. Fit together and support if
necessary. Allow excess material to cure, then
trim with a sharp blade. Sealant “skins” in 5
minutes, dries to touch in 1 hour. Fully cures and
bonds in 24 hrs.
DIAGRAM 5
mr
.
steam
®
Installation & Operating Instructions
______________________________________________________________
6
DIAGRAM 4
CAUTION
!
Drawings for Illustrative Purposes Only.
