4
mr
.
steam
®
Installation & Operating Instructions
______________________________________________________________
IMPORTANT NOTE:
See installation instructions for
the MSTS Temperature Probe
before rough-in or installation
of control
(pg. 8-9).
Installation Instructions for Round &
Square iTempo
™
and iTempo/Plus
™
STEP 1
Determine the desired installation location of the control.
The iTempo
™
and iTempo/Plus
™
controls are designed to
be installed inside or outside the steam room as a
matter of personal preference. If the control is
installed outside the steam room a Remote Temp-
erature Probe part number MSTS must be installed
inside the steam room. If the control is installed
inside the steam room the control must be located:
• 4-5 feet above the floor near the bather seating
area.
• The control features an integral temperature
sensor. Locate the control in a location repre-
presentative of the desired steambathing
temperatures. Do not locate the control above or
near the steam head or direct steam emissions. Locating
the controls near the steamhead or near direct steam
emissions may result in poor steam room temperature control.
• On a vertical wall
• The control cable length is 30 feet. Insure that the control
and/or steam generator are located accordingly.
Contact a Mr.Steam technical service representative if a
longer cable is required (60 ft. cable, PN 103990-60).
3-
7
⁄ 8”
Drawings for Illustrative Purposes Only.
DIAGRAM 1
2-
5
⁄ 8”
