- 34 -
END PANEL INSTALLATION
-End Glass is shipped installed on Floor model units.
-End glass is shipped loose on counter drop in units and will need to be installed after unit is placed in to
counter and lift handles are removed.
When placing cases in a line up, the number of end panels and end panel type may vary.
See Case Line Up Installation section of this manual.
1.
On each side of case there are (3) keyhole mounting slots for easier installation of glass. There is
(1) mounting hole in the front top corner of case to prevent glass from accidently popping off of end
of case.
2.
Screw (3) thumb screw about half way into end panel in location of the keyholes in case as shown.
3.
Align end panel thumb screws with keyholes and hook end panel on to case. Do not tighten thumb
screws.
4.
Align the mounting hole in top front corner of case with top front hole in end panel and attach with
¼-20 x .5LG thumb screw
5.
Tighten all (4) thumb screws by hand.
6.
Remove end panels in reverse order.
Summary of Contents for ITD Series
