Chapter 10: Servicing the Convergence Network
SmartSiren Platinum Convergence Network
62
Replacing a Terminal Insulator
To replace an insulator:
1.
Ensure that Keps nuts, the two lock washers, and the two flat washers are removed from the
terminal (Figure 10.4 on page 61).
2.
Note the locations of the locking tabs in Figure 10.5. Insert a flat-head screwdriver between
the housing and the insulator near the front locking tab and pry off the insulator.
Figure 10.5
Locking tabs on red insulator
TX
RX
PWR
ON
RAD
VOL
PA
VOL
SIREN
5A
HORN
SIREN
20A
FRONT LOCKING TAB
PRY HERE
REAR LOCKING TAB
SCREWDRIVER
1 / 2
3 / 4
Produces loud sounds
5 / 6
7 / 8
9 / 10
WARNING
*May cause hearing damage
*Wear hearing protection
*See instructions or call
1-800-433-9132
10A
AUX
11
12
13
14
6
7
8
9
10
14
13
12
11
AUX
AUX
AUX
AUX
AUX
AUX
AUX
AUX
INPUT
INPUT
INPUT
INPUT
LIGHTB
AR
ACTIVE
1
2
3
4
AUX
AUX
PWR
PWR
SM
SM
ON
RX
TX
AUX
AUX
AUX
AUX
1
2
3
4
5
AUX
20A
SM
290A7572
3.
Place the new insulator on the terminal and insert the rear locking tab into the housing.
4.
Push the front of the insulator against the housing to lock the front tab.
Reinstalling the Siren Amplifier/Relay Module
To reinstall the siren amplifier/relay module in the vehicle (Figure 10.4 on page 61):
1.
On the power terminals reinstall a flat washer followed by an external-tooth lock washer.
2.
Reconnect the power leads to the terminals and secure them with an external-tooth lock
washer and a Keps nut.
3.
Reconnect the Convergence Network cable, serial cables, and wiring.
4.
Reinstall the siren amplifier/relay module in the vehicle with the installer-supplied #10-32
mounting hardware.
