Chapter 5: Mounting the Siren and Control Pad
SmartSiren Platinum Convergence Network
41
To mount the siren amplifier/relay module in the vehicle:
1.
Use the base of the siren amplifier/relay module as a template (Figure 5.1) or the dimensions
shown in Figure 5.1 to mark the centers of the four mounting holes.
Figure 5.1
Slots for mounting hardware
1.05 in
(2.66 cm)
7.49 in
(19.03 cm)
7.94 in
(20.17 cm)
4.50 in
(11.43 cm)
MOUNTING SLOTS
(4 PLACES)
INSTALLER-SUPPLIED
#10-32 MOUNTING
HARDWARE REQUIRED
290A7560
2.
Tap and drill the center of the four mounting holes.
3.
Center the slots in the base of the siren amplifier/relay module over the drilled holes and secure it
with the installer-supplied #10-32 mounting hardware.
Mounting the Control Head
The control head comes with two mounting brackets and mounting hardware.
Tools needed:
• Drill with #9 drill bit
• Phillips screwdriver
• 7/16" nut driver
• Pencil or felt-tip pen for marking drill position locations
To mount the control head:
1.
Secure a bracket to the control head with the 6-32 x 1/4 Phillips screws and #6 lock washers
(Figure 5.2 on page 42).
2.
Using a 7/16" nut driver, secure the other bracket to the control head/bracket assembly with the
1/4-20 x 3/4 hex head screws and 1/4" lock washers (Figure 5.3).
