SmartSiren Platinum Convergence Network
16
CHAPTER 3
Connecting the Convergence Network
Before permanently installing the SmartSiren Platinum system, plan all wire routings and select the
mounting locations for the siren amplifier/relay module and control head. Also read and understand
all instructions included with related equipment before installing it.
Selecting Mounting Locations
When fastened to the back of the control head, the mounting bracket covers the wiring connectors and a
supplemental control for the gain or volume of the radio rebroadcast feature. To facilitate the installation
of the SmartSiren Platinum system, select mounting locations for the control head and the siren amplifier/
relay module before permanently mounting them in the vehicle. After completing the wiring described in
this chapter, refer to the instructions for mounting the control head and the siren amplifier/relay module in
Chapter 5 on page 40.
AIRBAG DEPLOYMENT: Do not install equipment or route wiring in the
deployment path of an airbag. Failure to observe this warning will reduce the
effectiveness of the airbag or potentially dislodge the equipment, causing
serious injury or death.
SEAT REMOVAL PRECAUTION: If a vehicle seat is temporarily removed, verify
with the vehicle manufacturer if the seat needs to be recalibrated for proper
airbag deployment.
UNIT REQUIRES AIR FLOW (SSP3000B ONLY): The siren amplifier/relay module
is cooled by an internal fan. Do not install it in areas where the air flow is
restricted. Do not mount the unit near a heater duct or under the hood.
MODULE IS NOT WATERPROOF: The housing of the siren amplifier/relay module
is NOT waterproof. The module must be mounted in a location that is sheltered
from falling rain, snow, standing water, etc.
For the control head, select a mounting location that allows the vehicle, controls, and microphone to
be operated safely under all driving conditions. To identify safe mounting areas for equipment inside
the vehicle, consult the vehicle manufacturer’s guidelines. To avoid driver distraction and unreliable
switch activation, the mounting location must not allow any movement of the control head. Do not
select a headded surface for the mounting location of the control head. For the siren amplifier/relay
module, suggested mounting locations are under the dash, under the front seat, or in the trunk under
the rear deck near the rear-seat speakers. Wiring connectors are located on the back of the siren
amplifier/relay module. Terminals for the ground and power connections are located on each side
toward the rear.
