FCI Watermakers DOCKSIDE TREATMENT SYSTEM PLUS Series, User Manual & Installation Manual

Page: 50 / 80

FCI WATERMAKERS, INC. 50 Operational Instructions
Service #2
The Service #2 Screen allows the user to test and run the system in a manual mode.
To turn on a setting, touch the gray circle, this will then turn into a
green circle which will indicate the item is on. To turn off an item, touch
the gray square and it will turn red after the item is turned off.
LP Valve
– Manually activate the low pressure valve.
HP Pump
– Manually turn on the high pressure pump.
Navigation Bar
– This allows the user to easily navigate between main screens.
Left Arrow
– Goes to page #1 of service.
Config #1
The Config #1 Screen allows the user setup special modes in which the unit can operate.
Hour Meter – An hour meter is located at the top center of the screen.
Tank Floats
– This allows the user to install tank floats on their product water tank,
and wire the floats to the controller (see instruction in wiring schematic). Once the
option is turned on, the controller will wait till both floats are dry before turning on
the unit. Once both floats are wet, the unit will shutdown and fresh water flush itself.
Max Run Time – This allows the user to setup the maximum amount
of time the unit will run. Once this option is turned on, the user will be
able to set the number of hours for which he wants the system to run
prior to the system shutting down and fresh water flushing itself.
Navigation Bar – This allows the user to easily navigate between main screens.
Left Arrow
– Goes back to the main setup screen.
Right Arrow
– Goes to page #2 of config.
DISPLAY SCREENS
(continued)