FCI Watermakers DOCKSIDE TREATMENT SYSTEM PLUS Series, User Manual & Installation Manual

Page: 49 / 80

FCI WATERMAKERS, INC. 49 Operational Instructions
Settings
The Settings Screen will allow you to adjust system settings
To adjust a setting, press the white number of the setting you would
like to adjust. Once pressed, a numeric keypad will come up.
Prod Temp Cal – This is your product temperature calibration.
This is set by the factory and can be adjusted if needed.
TDS High SP
– This is your TDS High alarm setpoint. This is set by
the factory but can be changed to the user’s requirements.
Navigation Bar
– This allows the user to easily navigate between main screens.
Left Arrow
– Goes back to the main setup screen.
Service #1
The Service #1 Screen allows the user to test and run the system in a manual mode.
To turn on a setting, touch the gray circle, this will then turn into a
green circle which will indicate the item is on. To turn off an item, touch
the gray square and it will turn red after the item is turned off.
Service Mode
- This allows the user to turn service mode on/off
which allows the user to manually run their machine. Service mode
can only be turned on when the machine is in standby mode.
Navigation Bar – This allows the user to easily navigate between main screens.
Left Arrow – Goes back to the main setup screen.
Right Arrow – Goes to page #2 of service.
DISPLAY SCREENS
(continued)