FCI Watermakers DOCKSIDE TREATMENT SYSTEM PLUS Series, User Manual & Installation Manual

Page: 15 / 80

FCI WATERMAKERS, INC. 15 Pre-Installation
DO NOT PERFORM INSTALLATION UNLESS:
1 . The system feed water valve is closed.
2. The system main electrical disconnect switch is switched
“OFF,” LOCKED,
and
TAGGED
.
WARNING: ELECTRICAL SHOCK HAZARD
. The installation
procedures expose the installer to
HIGH VOLTAGE
and electrical
shock hazard. Only attempt installation if you are a qualified
electrician and only if surrounding conditions are safe.
QUALIFICATIONS
Technicians must have technical knowledge and ability
in the following fields:
a) Electrical, Electronic, Electric Motors and Circuits
b) Electromechanical and Mechanical Systems
c) Hydraulic and Liquid Pressure and Flow Systems
d) Piping and Plumbing Systems
e) Water Suction and Pressure Lines
f) Thru-Hull Fitting below and above water level
WARNING:
Do not attempt installation, commissioning, troubleshooting,
or repair if you are not proficient in the above fields of expertise.
SPECIAL CONSIDERATIONS INSTALLATION CAUTIONS
Always allow hoses and tubes to enter and exit straight from the connection
for a minimum of one inch prior to a bend. If stress is placed on the
fitting due to a tight bend, the fitting will leak and may break.
Avoid skin and eye contact with the membrane packaging solution. In
case of skin contact, rinse the skin thoroughly with water. In case of eye
contact, flush repeatedly with water and notify a physician immediately.
R.O. membrane elements are stored in “sodium bisulfite.”
NEVER
mount liquid-holding component above any electrical or
electronic device. Extensive damage to the electronic device will result
if liquid enters device during maintenance or component failure.
CONNECTION LINE CAUTIONS
: All connection lines
should be as short and straight as possible using minimum
fittings. The connection lines must not be “kinked.”
ACCESSIBILITY CAUTIONS:
This is a simple rule. Install
the system and its supporting components in an accessible manner.
The panel must be accessible for operation of the system.
PRE-INSTALLATION
(continued)