FCAR FD505 Wheel Alignment System User Manual
15
of the steering wheel and use the steering wheel holder to lock it, as shown in the
figure. When measuring and adjusting the caster measurement, pull the handbrake
and hold the foot brake.
Figure 3.1-1 Steering wheel holder installation
3.2
Fixture/target installation
FCAR 5D four-wheel alignment system is equipped with 4 fixtures, 4 targets and 2
hosts. The host must be installed in the front position of the head of vehicle in the left and
right direction (refer to the 5D four-wheel alignment installation method). The front wheel
should install two short rod targets separately and the rear wheel should install two long
rod targets separately.
➢
How to install fixture/target
The fixture has been locked to the center position before leaving the factory. There is
no need to adjust the center and the fixture installation steps are as follows:
1)
Rotate the hand wheel to make the claws fit to the diameter of the rim. The
installation direction of the clamp is shown in figure 3.2-1;
2)
The clamp handle is up and perpendicular to the ground, and the four jaws should
stay to the edge of the rim closely;
