Fayat BOMAG BW 100 ADM-5, Operating Instruction

Page: 179 / 216

Protective equip-
ment:
n
Working clothes
n
Safety shoes
n
Protective gloves
1. Clean the area around the high pressure
filter.
2. Disconnect the high pressure oil lines from
the high pressure filter.
3.
Remove the high pressure filter and install
the new high pressure filter while paying
attention to the flow direction (arrow).
4.
Connect and tighten the hydraulic lines.
1. After the test run, check the filters for leaks.
2. Check the hydraulic oil level, top up if nec-
essary.
Ä
Chapter 8.11.1 ‘Changing the
hydraulic oil’ on page 174
3. Dispose of the hydraulic oil and filter in line
with environmental regulations.
8.11.3 Changing the coolant
Perform this maintenance work at
the latest after two years.
Do not start the engine after draining off the
coolant.
In case of lubrication oil entering into the
cooling system or a suspicious turbidity caused
by corrosion residues or other suspended
matter, the coolant must be drained off and the
complete cooling system needs to be cleaned.
Oil can damage the sealing materials used in
the cooling system.
High pressure filter
B-462-0062
Fig. 170
Concluding work
Maintenance – Every 2000 operating hours
BW 100 ADM-5 179