2-27
1
2
W
eb Settings Screen and Function Details
Device Screen
2-7-2 Direction
Select the increase/decrease direction of the measured value with the measurement as 0.
Near:
The closer the sensor and the target are to each other, the higher the measured value will be.
Far: The farther the sensor and the target are from each other, the higher the measured value will be.
Default value: Near
mm
0 mm
mm
mm
0 mm
mm
Target
Measurement center
Target
Measurement center
Sensor
Sensor
[Set to “Far”]
[Set to “Near”]
2-7-3 Laser
On/Off
Laser emission is stopped when set to OFF.
Measurement is also stopped when set to OFF. Set to ON under normal circumstances.
ON: Turns the laser ON and perform measurements.
OFF: Turns the laser OFF and stops measurement.
Default value: ON
2-7-4 Sensor
time
Displays the current time and the run time for the sensor.
When “Sensor time” is clicked, the time for the sensor will be adjusted to match the time of the clock on the
device being used (for example, the PC being used).
2-7-5 Setting data storage
'RZQORDGDQGVDYHVHWWLQJ¿OHVWRWKH3&
2-7-6 Setting data writing
Click “Select File” to select the data saved by “Setting data storage” to write saved setting data to the sensor.
This function can be used for writing settings to multiple sensors or to back up data if a malfunction occurs.
2-7-7 Factory
Reset
Press this button to reset all of the settings on the unit to the initial settings.
Ramco - Optex FA Divsion
www.Optex-Ramco.com
Got Questions? 1-800-280-6933
