FASTORA DAS-315SA Disk Array
19
Chapter 3 Configuration
FASTORA DAS-315SA can be configured via i a terminal or a web-browser.
This chapter will discuss the configuration methods and the detailed
information about the operation modes.
This chapter covers the following topics:
Configuring
Through
a
Terminal
Operation
Modes
Main
Menu
3.2.1 Connect a Terminal
Located at the rear of the DAS, a RS-232 connector, marked as
Con 1
can be
used to support the local terminal access. When connecting a terminal to the
DAS, make sure you have attached the supplied RS-232 cable to the right
connector. Note that you should set up the communication parameters before
using this terminal. To start up:
1. Plug one end of the supplied RS-232 cable to the port marked as
Con 1
at
the rear of the DAS.
2. Connect one end of the RS-232 cable to the COM port of your terminal or
PC.
3. Run an equivalent program of the terminal.
4. Change the setting of the terminal to match the default settings of the
FASTORADAS-315SA, namely:
Baud
rate:
115,200
Data bit: 8
Stop bit: 1
