FAST & FLUID MANAGEMENT srl
A Unit of Idex Corporation
4
Power supply
à
230-240 VOLTAGE: power supply with a magneto-thermal protection device that intervenes when current absorbed
exceeds 16 Amps or for leakage current of 30 mAmps, according to local regulations.
à
115 VOLTAGE: power supply with a magneto-thermal protection device that intervenes when current absorbed
exceeds 25 Amps or for leakage current of 30 mAmps, according to local regulations.
ELECTRICAL WIRING CAN BE ACCESSED BY QUALIFIED PERSONNEL ONLY.
DO NO OPERATE THE MACHINE IF THE SIDE OR REAR PANELS ARE NOT ASSEMBLED.
Safe use of the machine
The producer shall take the all possible care in planning, designing, the checking the installation and the start up of the
machine to guarantee the maximum operational level during a rational use of the system supplied.
All components must be in accordance with the current safety regulations. Up to date safety systems are installed in the
machine to ensure the best protection available at the moment.
While using SO300 you must keep to the following safety rules:
The “end-user” must keep to the safety regulations of the country where the machine is installed. If there is a
conflict between European regulation and local regulation, the most severe rule will apply on the specific
issue.
Installation and maintenance of SO300 shaker must be carried out by a qualified technician
.
Safety rules when the machine is operating
1. To avoid injuries, all panels of the body of the machine must be assembled and correctly fixed to the frame.
2. Do not tamper the protective control system and the door locking device.
3. Before any inspection and maintenance operation on SO300, disconnect it from the mains outlet to avoid
unexpected starts.
4. Do not leave inside the SO300 tools after servicing
5. Make sure the environment in which the machine is installed complies with the laws in force (you need to have an
authorization issued by the Fire Brigade or by the competent authority) and avoid a dangerous massing of paint
cans. It is forbidden to store flammable materials or other materials inside the machine. Using naked flames, white –
hot objects or any device that might generate sparks in the room where the machine is placed.
6. It is advisable to install a ventilation system, to guarantee that close to the machine the vapor dilution is lower than
30%
7. When work is finished, do not leave the can(s) inside the machine and do not leave the machine switched on.
8. In the premises where the SO300 is installed, within a 5 meter range from the machine, there must be a plate with
the writing “Smocking is strictly forbidden”.
SO300 shaker must not be installed in an working area classified as EX
WARNING!
Avoid operating the SO300 if it is not loaded with a can.
Never use a load with a weight over 35 Kg.
Remove all cans inside the machine before switching it off.
Do not place any
damaged can
inside the SO300. Consequent rupture during mixing may cause damage to
the shaker. Running the SO300 with damaged packaging is at User's risk.
Already damaged cans may cause damage to the your machine.
During the maintenance follow the security rules and the procedure described in this paragraph.
The SO300 is to be operated only by trained personnel. FAST & FLUID MANAGEMENT THE
NETHERLANDS shall not be liable for any damage or injury caused by non-compliance with the "user" and
"safety" regulations presented in this manual, or by not taking the usual and accepted precautions in
handling, operating or repairing, even if not expressly stated in this manual.
This is also valid for damage and/or accidents as a result of changes made to the machine that are
implemented without prior notice to and approval by FAST & FLUID MANAGEMENT THE NETHERLANDS.
