FAST & FLUID MANAGEMENT srl
A Unit of Idex Corporation
10
EMERGENCY BUTTON (when the machine is shaking)
•
Switch SO300 on
(just plug it in)
•
Open the door, load
a can and close the
door.
•
Press one of the start
buttons (T1, T2, T3) to
start the shaking cycle.
•
Before the end of the
shaking cycle, press the
emergency button
•
Shaking shall stop and a
warning noise shall be
heard.
•
The shaking cradle shall
stop and the upper plate shall
not unclamp.
•
The can shall be trapped in
the cradle and no button shall
work.
•
De-activate emergency
button by turning it
clockwise.
•
Press all buttons
(Stop/Up excluded). None
of them shall work
•
Press Stop/up button.
Make sure the upper plate
unclamps
•
Check the door: it shall
be unlocked.
14.3. Cleaning
All cleaning operations must be operated with the machine unplugged.
For inner parts cleaning, before unplugging the machine, open the door.
Body (panels) and door
Use any non abrasive cleaning product for domestic use on washable surfaces.
Control panel (keyboard)
Use a wet cloth. The use of neutral soap is allowed. Then wipe (no rinse) with a dry cloth or a paper towel.
Inner parts of the body
In case of paint loss, clean immediately!
Dried paint can be removed with a broad knife. Then Use any non abrasive cleaning product for domestic
use on washable surfaces.
Inner parts (shaking cradle)
In case of paint loss, clean immediately!
Dried paint can be removed with a
broad knife.
To clean lubricated parts, just use a
cloth, which will remove the paint
together with the lubricant.
Immediately restore the lubrication as
per further instructions
Accidental paint leakages/losses inside and/or outside the SO300
Immediately clean the machine and the floor of the ‘user area’ to avoid slipping risks.
Do not use water jets or high pressure cleaners to clean SO300.
Do not use solvents to clean SO300
In case solvents are absolutely necessary, after using them keep the machine disconnected from the mains
and its door completely open for at least 1 hour.
