Fasep RASE.3030, Instruction Manual

Page: 41 / 60

User Manual 41
WARNING
Proceed with care in this stage to avoid applying excessive stress to the tyre. It is recommended to
slightly lift up the presser tool at 6 o’clock in order to release a little bit the pressure on the tyre bead.
- Once the mounting phased is complete, raise the bead breaker disc and the bead presser tool
(control 21).
- Return the lever-less head into its rest position (control 13).
NOTE: If the sector of the tyre bead placed between bead presser tool and disc is not kept correctly
inserted in the rim groove, it is recommended to use a supplementary bead pressing clamp (op-
tional). In this case the following procedure must be applied:
- After having positioned on the tyre the bead breaker disc, lock the bead pressing clamp on the rim
near (at approximately 3-4cm from the disc – Fig. 28).
- Rotate the wheel until the clamp is at 5 o’clock position and Check that the portion of the tyre bead
(between disc and clamp) is inserted in the groove of the rim.
- If not, position the bead pressing tool at 3 o’clock to press the bead into the rim grove.
- Restart the rotation to complete the mounting phase.
- Remove clamp, bead pressing tool, lever-less head and bead breaker disc.
8• Set the bead breaking unit to the rest position
9• Tyre inflation
- For inflation, see “INFLATION” section.
10 • Unlock the wheel from the turntable (fig.30)
29