Fasep RASE.3030, Instruction Manual

Page: 40 / 60

40 User manual
26
4 • Upper bead positioning (fig. 27)
- Position the upper tyre bead.
Take care that the tyre does not slip underneath the tool.
5 • Bring the bead breaking unit closer
6 • Bead breaker disc positioning (fig. 28)
- Lower the bead breaker disc (control 21) (A) until it is level with the well of the rim.
7 • Upper bead mounting (fig.29)
- Rotate the wheel using pedal 15 to start mounting the upper bead. Press manually the tyre bead
to keep it inserted in the channel until the bead assembly is successfully completed (alternatively
use the bead presser IPH).
NOTE: for oversized (more than 19’’) or particularly tough wheels, it is recommended the use of the
pneumatic bead presser IPH. In this case the following procedure must be applied:
- Position the bead pressing device (B1, Fig. 8) near the bead breaker disc (approximately 3-4cm).
Lower it until the bead reaches the height of the rim groove.
WARNING
Risk of crushing. Positioning the bead-pressing tool against the tyre could be dangerous in some
respects. Never place any part of the body, particularly hands between tools and wheel.
- As the turntable turns, the bead pressing tool will revolve with the tyre, keeping the bead inserted
inside the rim groove and thus avoiding any effort or danger to the operator and for the rim .
27
28