Farm King TVR12, Operator And Parts Manual, Page: 45 / 112

Operation - TVR12, TVR14, TVR16 V-Rake
43
Pre - Operation Checklist
Before operating the V-Rake for the first time and
each time thereafter, check the following items:
1. Lubricate the equipment per the schedule outline in
the Maintenance Section.
2. Check the hitch for damaged, loose or missing parts.
Repair as needed before operation.
3. Make sure that all guards and shields are in place,
secured and functioning as designed.
4. Check condition of all hydraulic components for
leaks. Repair as required.
WARNING
HIGH PRESSURE FLUID HAZARD
Leaking fluids under pressure can enter the skin
and cause serious injury or death. Immediate
medical attention is required. Wear goggles. Use
cardboard to check for leaks.
Note: Do not operate with hydraulic leaks.
6. Check that all electrical connections are tight.
7. Check the tines. Remove any twine, wire or other
material that has become entangled.
Entering The Operator’s Position
Enter the operator’s position, start the engine, and
release the parking brake.
IMPORTANT
Follow the instructions in your tractor’s operation
manual for the correct procedure.
Leaving The Operator’s Position
Always perform the following steps when leaving
the operator’s position:
WARNING
AVOID INJURY OR DEATH
Before you leave the operator’s position:
• Always park on a flat level surface
• Place all controls in NEUTRAL
• Engage the park brake
• Stop the engine and remove the key
• Wait for all moving parts to stop
Tractor Requirements
The V-Rake requires a tractor with 40 HP and two
pairs of remote outlets.
Adjust the tractor’s drawbar in / out, until the
center of the hitch pin hole is 16” from the end of
the tractor’s PTO shaft.
See your tractor’s owner’s manual for correct
adjustment procedures.