Faraday MPC-6000, Programming Manual

Page: 25 / 40

M P C 6 0 0 0 / 7 0 0 0 P R O G R A M M I N G M A N U A L
21
Starting Quick Test
The Quick Test mode allows quick and easy testing of the installation. It will allow
the devices to be activated and the NACs to sound for a short period of time.
Press “Quick
Test”. Press “Start”. The display will
prompt for a “Yes” or
“No” confirmation to
start Quick Test. Press “Yes” to start Quick Test. The
display will show NAC sound time
and the status of the printer and the
time until autoexit. Pressing “Stop”
will reset the panel.
Configuring NAC sound time for Quick Test
The period of time that the NACs will be active after each event in Quick Test is set
as follows:
Press “Quick
Test”. Press
“Configure”. Press “NAC time”. The display will
indicate the time
in seconds that
the NACs will
sound during
Quick Test.
Use the “Inc” and
“Dec” buttons to
set the time either
to “off” or from 1
to 30 seconds.
Configuring the printer during Quick Test
Printing may be enabled or disabled during Quick Test as follows:
Press “Quick
Test”. Press
“Configure”. Press “Printer”. The display will
indicate whether
the printer is
enabled or
disabled during
Quick Test. Use the
“Enable/Disable”
button to change
state. The display
will toggle to
indicate the state.
Programming a Device
It is possible to program a device address without the programming tool. Following is
the procedure that is used when adding a new device to the loop.
Press “more” twice
then press
“Program device”. The panel will
display a
message as it is
looking for the
new device. When a new
device has been
found the display
will show a
screen to enter a
device address. Use the keypad
and “Program”
buttons to enter
the address and
program the new
device. Pressing
“Clr” will clear the
entry.